C# Compiler Error
CS0163 – Control cannot fall through from one case label (‘label’) to another
Reason for the Error
You will receive this error when you DONOT explicitly terminate a switch statement in C#.
For example, try compiling the below code snippet.
using System; namespace ConsoleApp2 { class Program { public static void Main() { int val = 10; switch(val) { case 1: Console.WriteLine("Case 1"); case 2: break; } } } }
You will receive the error code CS0163 in C# for the above code snippet because the section (case 1 ) is not terminated explicitly using break.
Error CS0163 Control cannot fall through from one case label (‘case 1:’) to another ConsoleApp2 C:\Users\Senthil\source\repos\ConsoleApp1\ConsoleApp2\Program.cs 12 Active
Solution
When the switch statement contains multiple cases, it will need to be terminated by one of the following keywords : return, goto, break, throw, continue.
The error in the above code can be fixed by adding break to terminate the case 1 as show below.
using System; namespace ConsoleApp2 { class Program { public static void Main() { int val = 10; switch(val) { case 1: Console.WriteLine("Case 1"); break; case 2: break; } } } }
Appliqué, Patchwork and Quilt Stitching 83
3
■ Using the optional quilting guide
Use the quilting guide to sew parallel stitches that
are equally spaced.
1
Insert the stem of the quilter into the hole at
the rear of the walking foot or presser foot
holder.
Walking foot
Presser foot holder
2
Adjust the stem of the quilter so that the quilt
guide aligns with the seam that has already
been sewn.
Free-motion quilting
With free-motion quilting, the feed dogs can be
lowered (using the drop feed lever) so that the fabric
can be moved freely in any direction.
The optional quilting foot is needed for free-motion
quilting.
1
Remove the presser foot and the presser foot
holder.
•Refer to “Removing the presser foot holder”
(page37).
2
Align the quilting foot with the lower-left side
of the presser bar.
The pin on the quilting foot should be
positioned over the needle clamp screw.
1Pin on quilting foot
2Presser foot holder screw
3Needle clamp screw
3
Hold the quilting foot in place with your right
hand, and then tighten the presser foot holder
screw using the screwdriver in your left hand.
1Presser foot holder screw
● Be sure to securely tighten the screws
with the screwdriver, otherwise the
needle may touch the presser foot,
causing it to bend or break.
2
3
1
1
CAUTION
S2_brotherE.book Page 83 Thursday, February 13, 2003 11:03 AM